Another useful SRX command for looking at IPSec tunnels

12 08 2015

This is a new one on me – obviously I’ve not been paying much attention since it has been around since 10.2!

On 12.1X45-D15.5 the counters for packets/bytes all show zero, but at least you can see that your tunnel is up and what the various parameters in use are…  See below: Read the rest of this entry »





Useful SRX debugging blog

12 08 2015

Just came across a useful debugging guide for site-to-site IPSec VPNs on Juniper SRX. It is a bit confusing because in steps 2 and 3, where it says [LOCAL PEER IP] it should actually say [REMOTE PEER IP].   But otherwise, this is a very useful set of instructions. Read the rest of this entry »